Schlüter®-SHOWERPROFILE-S / -R | Installation | Schlüter-Systems



The protective foil must be removed before installation.


  1. After cutting to length, press the trapezoid perforated anchoring leg of the support profile into the previously applied tile adhesive on the floor and align.
  2. Measure the required length and height of the tapered profile (front: lowest height; rear: greatest height). Keep in mind the insertion depth into the U shaped groove.
  3. Cut the tapered profile to size for the required height.

Simply cut the profile at the narrow and/or broad end to cut it to the required height and length. Apply tile adhesive to the back of the cut tapered profile and insert it into the U shaped support profile. Press it in place and align it flush with the floor or wall.


  1. Determine the length and height of the exposed wall area to be covered and cut the profile to the required length.
  2. Connect the two components of Schlüter®-SHOWERPROFILE-R to achieve the desired height.
  3. Apply a sufficient amount of adhesive to the fleece fabric, which is laminated on the reverse of the profile, and set the profile in place so that it is flush with the tiles.

Contact Schlüter-Systems Ltd

Units 3-5 Bardon 22,
Beveridge Lane, Coalville,
Leicestershire, LE67 1TE
Phone: +44 (0) 1530 813396

Quick contact list

Reach the department of your choice directly via email:

Write To Us!

Do you have a question or suggestion?

Further information

on our products and specifications can be found here:

Metal surfaces
Metal surfaces

All surfaces at a glance

Legend "Products"

We use the following symbols and abbreviations to illustrate our price charts.

image image

= new products

= radius perforation available   


H = height
L = length
B = width

PL = euro pallet 
KV = case packaging 
BV = bundle (there is a 10 item bundle packaging for all the profile types)
P = box packaging 
R = roll
St. = unit