Cookies on the Schlüter-Website

Cookies help us deliver our services. By using our services, you agree to our use of cookies. Further information

logo

Schlüter®-ARCLINE-APE

Installation

  1. Select Schlüter-ARCLINE-APE according to tile thickness. Apply tile adhesive to the area where the profile is to be installed, using a notched trowel. Note: The corresponding profile installation height must be taken into account for the individual accessories; see product data sheet 2.20 Schlüter-ARCLINE-ACCESSORIES. We generally don’t recommend installing the profile below a height of 70 cm.
  2. Press the perforated anchoring leg of Schlüter-ARCLINE-APE firmly into the adhesive and align it.
  3. Trowel additional adhesive over the perforated anchoring leg to ensure full coverage and fill the open profile chambers on the reverse side with tile adhesive.
  4. Firmly press the adjoining tiles into place and align them in such a way that the upper profile edge slightly extends over or is flush with the tile (the profile should not be positioned below the top level of the covering; preferably, it should protrude by approx. 1 mm).
  5. The tile is set to the lateral joint spacer, which creates an evenly spaced joint of 1.5 mm.
  6. The pre-adhered decorative insert prevents the grout from entering the profile during installation. It must be removed immediately after grouting.
  7. You can now insert Schlüter-ARCLINE accessories or reapply the decorative insert after rinsing it off in clean water.

    Installing ARCLINE accessories 
  8. Check the proper placement of the rounded end into the latch.
  9. Place the accessory parallel to the wall with the latch in front of the receiving profile.
  10. Slowly tilt the accessory toward the top (up to max. 40°), while pushing lightly at the level of the receiving profile.
  11. The accessory audibly clicks into the receiving profile.
  12. Slowly bring the accessory to its final position by resting it against the wall.
  13. Snap the supplied decorative clip on the clamping profile between the wall and the glass support panel.
  14. Use two decorative clips if there are two clamping profiles.
  15. Optionally attach the supplied spacers (a. silicone spacer, b. suction cup) at the lower end of the accessory or the wall

    Note: To remove the accessory, take off the installed decorative clips with the supplied accessory lever and repeat the above steps in reverse order. In this case, slightly pull at the level of the receiving profile instead of pushing.

Contact Schlüter-Systems Ltd

Units 3-5 Bardon 22,
Beveridge Lane, Coalville,
Leicestershire, LE67 1TE
Phone: +44 (0) 1530 813396

Quick contact list

Reach the department of your choice directly via email:

image
Write To Us!

Do you have a question or suggestion?

Further information

on our products and specifications can be found here:

Metal surfaces
Metal surfaces

All surfaces at a glance

Legend "Products"

We use the following symbols and abbreviations to illustrate our price charts.

image image

= new products

= radius perforation available   

 

Dimensions:
H = height
L = length
B = width


Packaging:
PL = euro pallet 
KV = case packaging 
BV = bundle (there is a 10 item bundle packaging for all the profile types)
P = box packaging 
R = roll
St. = unit