Schlüter®-KERDI-FIX | Installation | Schlüter-Systems



The application area must be weight-bearing and sufficiently solid. The surface where the adhesive is to be applied must be suitable for adhesives and bonding, solid and free of loose debris. Materials must not include any volatile components that may interfere with the bond later. If applicable, conduct your own testing on site to verify suitability.

Schlüter-KERDI-FIX as an installation adhesive:

Apply Schlüter-KERDI-FIX as a line or spot. For complete curing on non-absorbent or extremely dry materials, KERDI-FIX can be moistened with water. Fit together the components to be adhered during the skin-forming time; spraying KERDI-FIX with water significantly shortens the skin-forming time. If necessary, secure the work pieces in an undisturbed location until the adhesive has fully cured.

Schlüter-KERDI-FIX for waterproofing:

To adhere Schlüter-KERDI or Schlüter-KERDI system components, apply KERDI-FIX on the substrate and evenly spread it with a finely notched trowel. Fully embed the materials to be adhered as quickly as possible, avoiding all cavities. We recommend drawing the smooth side of the notched trowel over the KERDI membrane or using a suitable pressure roller for adhering the KERDI material. Make sure there are no air bubbles.

KERDI-FIX as an exposed joint:

Properly cover all edges, e.g. with masking tape, prior to applying KERDI-FIX to joints. The tape may not reach into the joint. To avoid three-point adhesion, press a backfill line with a suitable diameter into the joints. Fill the joint with Schlüter-KERDI-FIX without leaving any cavities. Remove any excess material with a trowel. Then remove the adhesive tape and smooth the joint with the help of water or a suitable smoothing agent.

Note: Exposed joints require maintenance.

Contact Schlüter-Systems Ltd

Units 3-5 Bardon 22,
Beveridge Lane, Coalville,
Leicestershire, LE67 1TE
Phone: +44 (0) 1530 813396

Quick contact list

Reach the department of your choice directly via email:

Write To Us!

Do you have a question or suggestion?

Further information

on our products and specifications can be found here:

Legend "Products"

We use the following symbols and abbreviations to illustrate our price charts.

image image

= new products

= radius perforation available   


H = height
L = length
B = width

PL = euro pallet 
KV = case packaging 
BV = bundle (there is a 10 item bundle packaging for all the profile types)
P = box packaging 
R = roll
St. = unit