Schlüter®-BARIN | Installation | Schlüter-Systems



  1. Schlüter®-BARIN gutter components are cut to size and connected to the Schlüter®-BARA profile with the screws provided. The slots allow the gutter to be sloped, if required.
  2. A waterproof connection between two abutting gutter sections is achieved by centring a connector over the joint.
  3. The rubber seal ensures a waterproof connection at the joints.
  4. For inside and outside corners, the corner pieces are attached using two connectors, centred over the joint.
  5. To connect a down pipe, a gutter section with an outlet of approximately 20 cm is attached with two clip on connectors, which are centred over the gutter joints.
  6. The end caps are held against the gutter from below and attached with a connector.
  7. The screws and slots are covered by clipping on the cover profile.
  8. The last step is to adhere the edge covers.

Contact Schlüter-Systems Ltd

Units 3-5 Bardon 22,
Beveridge Lane, Coalville,
Leicestershire, LE67 1TE
Phone: +44 (0) 1530 813396

Quick contact list

Reach the department of your choice directly via email:

Write To Us!

Do you have a question or suggestion?

Further information

on our products and specifications can be found here:

Metal surfaces
Metal surfaces

All surfaces at a glance

Schlüter colour key
Schlüter colour key

From brilliant white to brick red - here you will find an overview of all available product colours.

Legend "Products"

We use the following symbols and abbreviations to illustrate our price charts.

image image

= new products

= radius perforation available   


H = height
L = length
B = width

PL = euro pallet 
KV = case packaging 
BV = bundle (there is a 10 item bundle packaging for all the profile types)
P = box packaging 
R = roll
St. = unit